Radiators not heating evenly? Cold patches? System slow to warm up?
It could be time for a power flush — and the earlier you catch it, the better.

At EPM, we see this issue a lot in Exeter and across Devon — especially in older systems or homes that have had a new boiler fitted but not had the pipework cleaned properly.

So how do you know if a power flush is actually needed? And what does it involve?

First — What Is Power Flushing?

Power flushing is a deep clean of your central heating system.
We connect a special machine to your pipework and push water and cleaning chemicals through the radiators and boiler to clear out sludge, rust and debris.

The aim is to get your system back to full flow — improving heat output, efficiency and lifespan.

5 Signs You Might Need a Power Flush

1. Cold Radiators at the Bottom

Sludge tends to settle at the base of the radiator. If the top is hot but the bottom is cold, it’s often the first clue.

2. Noisy Boiler or Radiators

Kettling, banging, or gurgling sounds usually mean restricted flow or trapped air — often caused by sludge buildup.

3. Some Radiators Don’t Heat at All

Even with the system balanced and bled, some rads just don’t warm up. It could be blockage in the pipes or valves.

4. Discoloured Water When Bleeding

If you bleed a radiator and the water is dark or sludgy, that’s corrosion and debris from inside the system.

5. Frequent Boiler Lockouts or Error Codes

Modern boilers will shut down or show faults if they detect poor flow or restricted heat exchange.

When Power Flushing Makes the Most Sense

We usually recommend a flush:

• Before installing a new boiler on an old system

• If you’ve had repeated radiator or pump issues

• When controls and settings are fine, but heating is still poor

• After long periods of the heating being unused (e.g. empty properties)

Not every issue needs a power flush — but it’s often cheaper and quicker than replacing radiators or pipework unnecessarily.

What Does It Cost?

For a standard 3-bed house, you’re typically looking at:

• £450–£700 depending on the number of radiators, system condition, and layout

Larger or heavily sludged systems may cost more — but we’ll always assess and quote honestly, without upselling.

We also offer magnetic filters and chemical inhibitors to help prevent future build-up.

Final Word from EPM

If your radiators are struggling and you’ve ruled out the basics, a power flush could bring your whole system back to life.
We’ll test your flow rates, check the system condition, and tell you honestly whether it’s worth doing — or if a simpler fix will do the trick.